+8618700875368

Salt Water Test Device Earphone Test

Feb 16, 2023

Purpose of the Test


Salt Water Test Device Earphone Test is mainly to determine the resistance of the earphones under the influence of the salt fog climate environment.

 

Test Conditions


NaCl solution with a salt spray concentration of 5%, continuously sprayed at 35°C for 24 hours, and then removed for 16 hours to dry.

 

Minimum sample quantity: 10 pcs

 

Test Equipment


LIB salt spray test chamber

Salt Spray Test Chamber Earphone Test

Salt Spray Test Chamber Earphone Test 2

 

Test procedure


■Samples were pretreated at 35°C for 2 hours before the salt spray test.

■The samples were exposed to salt spray environmental conditions for 24 hours.

■After the test, take out the sample and wipe the surface with a rag to clean the salt water, recover at room temperature for 16 hours, use a soft brush to gently sweep off the surface matter, and after the sample is taken out, wash it with flowing warm water at a temperature not higher than 35° Sample 1 to remove residual salt spray solution on the surface of the sample. Recover at room temperature for 16 hours.

■ After cleaning, the electrical and mechanical properties of the whole machine will be tested, and the appearance of the earphones will be tested.

 

In Conclusion


■The electrical performance of the earphones is completely normal, the moving parts are not mechanically bonded, and the important decorative materials cannot be affected by corrosive substances, such as dents, blisters, discoloration, etc. The intrusion of salt spray into the earphones cannot affect the current and future use of the earphones .

 

■There is no obvious change in the appearance of the earphones, such as rust, discoloration, and peeling off of the plating, etc.

Send Inquiry