Salt Fog Testing Chamber

LIB Environmental Simulation Industry is one of the most reliable manufacturers and suppliers of salt fog testing chamber in China, featured by quality products and low price. Welcome to buy CE approved salt fog testing chamber in stock here and get quotation from our factory. Contact us for discount information.

Introduction

Salt fog testing chamber is used to test the corrosion resistance of various materials after their surfaces are treated by electroplating, anodizing, spraying and anti-rust oil anti-corrosion treatment.

Salt fog corrosion test chamber can be used to assess the ability of salt spray corrosion resistance of materials and their protective coatings, as well as the process quality comparison of similar protective coatings, and can also be used to assess the ability of salt spray corrosion resistance of some products.Equipment can reach in the experiment work space from room temperature to 60 ℃ between any one temperature point, and maintain a constant.

Parameter

Product Design Details

Material The entire glass fiber board system, strong structure, never deformed, and acid and alkali resistant high temperature never aging.	Brine Tank Built-in 30 liter salt solution tank with a brine mixing system to keep the brine even ,The salt water has a better uniformity and the salt is not easy to precipitate
Nozzle Precision glass nozzle fog spread evenly, and naturally fall on the test piece, to ensure that no crystalline salt blockage.	Controller PID control system, set the test parameters by button type. the error ± 0.1 ℃, large set up time up to 999HrS.

Chamber making materials

1. Salt spray test chamber is made of imported glass fiber reinforced hard plastic board, with smooth, clean and smooth surface, aging resistance and corrosion resistance;

Salt spray fog test chamber can better meet the requirement of long-term strong acid and strong salt spray test without any damage.

2. The cover of the box is made of fully transparent imported impact resistant plate, which is convenient to observe the test condition of the test sample during the test

Characteristics

●Salt fog settlement: 1~2ml (80cm ^ 2 /h)

●Spray mode: continuous, cycle optional

●Test timing: adjustable from 1 to 99999 (hours, minutes, seconds)

●Temperature sensor: platinum resistance, PT100 Ω/MV

●Heating system: fully independent system, titanium alloy electric heating heater

●Spray system: tower spray device with no crystallized nozzle (the mist particles are finer and evenly distributed)

●Spray time: 1~99999 (hours, minutes, seconds) with adjustable cycle

●Salt liquid collection: standard funnel and standard measuring cylinder

●Salt-liquid filtration: install water quality filter at suction pipe (stop test to prevent nozzle blockage)

●Preheating of salt and liquid: the temperature of salt and liquid is balanced with the temperature in the tank (the temperature of salt and liquid is not too low to affect the test temperature)

Precautions for Use

1. The power is plugged in, so don't loosen it.

2. Confirm the automatic water supply and gas supply system.

3. Keep the sink sealed and confirm.

4. Whether the vent hole is free and there is no foreign body.

5. After the test, the power supply, air source and water source of the equipment should be cut off in time to prevent the device from being in standby mode.

>>>Contact us for free spare parts

Hot Tags: salt fog testing chamber, manufacturers, suppliers, factory, cost, price, used, specification, for sale, salt spray Test cabinet, salt spray tester machine, salt fog test chamber, corrosion chamber, Cycle Salt Spray Chamber, Fog Salt Spray Test Machine